AMETEK HPD Series GPIB-Multichannel - Manual (Page 112)

108
Oper
ating
Manual
for Multichanne
l F
unctionality (
G
PIB-
M)
SCPI Command Re
fe
rence
SCPI C
o
mman
d Summary
Table B.7Commands for Fold Protection
Table B.8Commands for Triggering
Table B.9System Commands
Function SCPI Command Description Query
Set Output Fold Delay [:]OUTPut[]:PROTection:FOLD:DELay Set the delay time (seconds) before fold
protection is triggered. Yes
Set Output Fold Mode [:]OUTPut[]:PROTection:FOLD[:MODE]
{NONE|CC|CV}
Select which regulation mode to fold back
(None,CV, CC, CP) Yes
Query Fold Protection
Tripped [:]OUTPut[]:PROTection:FOLD:TRIPped? Query if fold protection has tripped N/A
Function SCPI Command Description Query
Set Immediate Initiation of
Trigger System [:]INITiate[][:IMMediate] Initiate a triggered event or sequence N/A
Set Trigger Source [:]TRIGger[][:SEQuence]:SOURce
{BUS|EXTernal|IMMediate|NONE}
Sets the trigger source for triggered
setpoints Yes
Function SCPI Command Description Query
Query System Error [:]SYSTem[]:ERRor[:NEXT]? Returns the next error in the instrument’s
error queue N/A
Recall Default Factory
Preset [:]SYSTem[]:RECall:DEFault Restore the factory preset values N/A
Select Remote Control
Source [:]SYSTem[]:REMote:SOURce {GPIB|MCHannel} Change the remote control source Yes
Set Multichannel Address [:]SYSTem[]:COMMunicate:MCHannel:ADDRess Select the multichannel unit address Yes
Set GPIB Address [:]SYSTem[]:COMMunicate:GPIB[:SELF]:ADDRess Configure GPIB address Yes
Set GPIB Power On
Service Request [:]SYSTem[]:COMMunicate:GPIB[:SELF]:PONSrq
{ON|OFF|0|1}
Configure GPIB PON SRQ Yes
Set Remote Control
Operation (Serial
Interface) [:]SYSTem[]:REMote:STATe
{LOCal|REMote|RWLock}
RS-232 Only. Change remote control mode Yes
Query SCPI Version [:]SYSTem[]:VERSion? Returns the SCPI version to which the
instrument complies. Format is YYYY.V N/A