AMETEK HPD Series GPIB-Multichannel - Manual (Page 11)

vii
About This Manual
This operating manual is for the internal Multichannel Interface (GPIB-M), a
microprocessor-controlled option card for your DC output power supply. This
manual provides you with descriptions and specifications, user options, and
configuration instructions, in addition to a command set which enables you to
manage the power supply from an external source. Error messages and calibration
procedures are also included.
This manual is designed for the user who is familiar with basic electrical theory
especially as it applies to the operation of power supplies. This implies a recognition
of Constant Voltage and Constant Current operation modes and the control of input
and output power, as well as the observance of safe techniques while effecting supply
or pin connections and any changes in switch settings. The user should also have
experience with a computer-based communications software package.
Refer to your power supply manual for installation, configuration, and operating
procedures for your power supply.
Main Sections
Section 1 Features and Specifications Describes the power supply and lists
its features and specifications.
Section 2 Installation and Configuration Gives basic setup procedures.
Describes inspection, cleaning, shipping, and storage procedures. Includes
additional options for configuring the GPIB-M interface for operation.
Section 3 Operation Describes operation of each feature.
Section 4 Status Registers Details status registers and how to use them to
monitor the power supply status.
Section 5 Current Sharing Explains how to configure the power supply for
current sharing among units connected in parallel.
Appendix A GPIB Describes the General Purpose Interface Bus (GPIB)
commands and lines supported by specific products with the Multichannel Interface
installed.