Xtramus DApps-MPT V1.4 - Manual (Page 378)

378
E-mail: [email protected]
Website: www.Xtramus.com
XTRAMUS TECHNOLOGIES ®
9.4.2. CON (Serial Port) – Check Test
Con (Serial Port)
– Check Test checks and sees if DUT responses the pre-defined keyword correctly via
DUT’s RS232 interfaces.
A. Setup
 CON Port Information: This table shows information regarding to the testing serial port.

Port: CON port of the IPC or the PC that control the chassis

Baud Rate: Transmission speed.

Data Bits: Data length of a segment.

Stop Bits: Stop bits of a segment

Parity: The method to check the
correctness

Setup: Click this button to set the values
on COM Port Information table. You can
click Default to set all values to default, Apply to apply all the changes you ’ve made, or Cancel
to exit without any changes.
 Keyword Setup: You can set the keyword for testing here.

Keyword Case Sensitive: Enable this function and set the Keyword authentication to case
sensitive.

Halt on if Fail: If you enable this function, system will stop if the test fails.

Check Keyword: You can input the keyword here in this field.

Wait Before Check: System will halt for the set amount of seconds before checking keyword.

Wait After Check: System will halt for the set amount of seconds after checking keyword.

CON-Check Result if Keyword is present: If the keyword is found, you can set the result of the
test to be Pass or Fail.