Xtramus DApps-MPT V1.4 - Manual (Page 29)

29
E-mail: [email protected]
Website: www.Xtramus.com
XTRAMUS TECHNOLOGIES ®
5. Function Description
Built-in tasks in DApps-MPT include DUT OSC, Unicast, Flow Control, Broadcast, Filter, CRC Error, Ping
and Console port tasks.
5.1. Performance Task in Layer 1 (PT1)
DUT OSC Test
Test the speed rate of the DUT
By using this utility, operator is able to measure oscillator's speed of DUT that is either faster or slower
than standard speed in ppm scale, or use it as criteria to judge the result of test.
5.2. Performance Tasks in Layer 2 (PT2)
A. Unicast Test
Unicast transmission is the sending of information packets to a single destination. In layer 2 test, unique
MAC address is the key of single destination as illustration below.
Perform unicast test on DUT in layer2 with different speeds, mode and various configurations.

PT2-UC-10H (10Mbps Half Duplex),
 PT2-UC-10F (10Mbps Full Duplex),
 PT2-UC-100H (100Mbps Half Duplex),
 PT2-UC-100F (10Mbps Full Duplex),
 PT2-UC-1G (1000Mbps Full Duplex),
 PT2-UC-FULL (Perform Unicast performance test by two groups settings with different media type
such as 100Mbps and 1000Mbps for DUT ports with different maximum speeds)