Tempest Tornado - Manual (Page 39)

Tornado Enclosure User Manual page 39
Martin MAC III and other tall Luminaires
The MACIII is too tall to use in a Tornado 2300 with Omega Clamps installed in the usual way. In this
case, and in similar cases, the fixture must be secured in place with the omega clamp BELOW the
fixture tray.
1. Remove the Fixture tray from the enclosure, as shown above.
2. Carefully place the fixture on its side on a flat surface, and identify the mounting holes in the
Fixture Tray that line up with the fixture mounting locations.
3. Fit the quarter-turn fasteners through the Fixture Tray into the receptacles in the fixture
base:
4. Mount the omega clamp into the quarter-turn sockets in the fixture base, through the holes
provided in the fixture tray.
5. Make sure that all quarter-turn fasteners are fully rotated (clockwise) and positively locked,
and that the luminaire is firmly attached to the fixture tray
6. Replace the fixture tray/fixture assembly in the enclosure, and use the 5/16 bolts provided
to secure firmly in place
Fixture Tray
Fixture Omega
Clamp