Tempest Tornado - Manual (Page 12)

Cyclone Enclosure User Manual page 12
Pipe Mounting Pipe Clamps
4900.MCT Pipe clamp, for pipes 1.5” (38mm) to 2” (50mm) OD.
Order TWO per enclosure.
4925.MCT Pipe clamp, for pipes 2” (50mm) to 2.5”/64mm OD.
Order TWO per enclosure.
Pipe Clamps mount to the enclosure base in the same
locations as the mounting brackets provided.
NOTE: Chesboro’ style half-couplers may be used for
temporary installations, but are not recommended for
permanent installs.
Mounting – Tornado 2000 and up
 Each Enclosure must be mounted with FOUR points.
 Tempest Lighting recommends only stainless steel mounting hardware.
 The bolts attaching the enclosure to its shipping pallet are mounting bolts. Do not Discard.
 All mountings must be made using the two Unistrut channels on the base of the enclosure.
Pipe Mounting
Pipe Clamps
4900.MCT Pipe clamp, for pipes 1.5” (38mm)
to 2” (50mm) OD. Order FOUR per enclosure.
4925.MCT Pipe clamp, for pipes 2” (50mm) to
2.5”/64mm OD. Order FOUR per enclosure.
Note: These parts are supplied with the
Tornado enclosure .