Tempest Tornado - Manual (Page 26)

Cyclone Enclosure User Manual page 26
Note: If the enclosed equipment does not use DMX, then connector (2) on the controller is DMX OUT
for the enclosure.
DMX Line Terminations
DMX cable runs must be terminated at the far end of the cable run with a termination resistor as
detailed in the DMX512 standard.
The individual equipment installed inside the
Tempest enclosures must NOT be terminated.
It is recommended that any line termination is
done using the 3-pin terminal connector fitted
to the DEC3.3 control circuit board.
+ ‒ G
DMX OUT
+ ‒ G
DMX OUT
LIGHT
+ ‒ G
DMX IN
LIGHT
+ ‒ G
DMX IN
DMX terminal Pinout Detail