2002 dodge hemi, Recommended tools for installation – Paxton Superchargers 5.7L Dodge Hemi User Manual

Page 4

P/N: 4809650

11NOV04 v1.0 03DodgeHemi(4809650v1.0)

efore beginning this installation, please read

through this entire instruction booklet and

the Street Supercharger System Owner's

Manual which includes the Automotive Limited

Warranties Program and the Warranty Registration

form.
Paxton supercharger systems are performance

improving devices. In most cases, increases in

torque of 30-35% and horsepower of 35-45% can

be expected with the boost levels specified by

Paxton Automotive. This product is intended for

use on healthy, well maintained engines.

Installation on a worn-out or damaged engine is

not recommended and may result in failure of the

engine as well as the supercharger. Paxton

Automotive is not responsible for engine damage.
Installation on new vehicles will not harm or

adversely affect the break-in period so long as fac-

tory break-in procedures are followed.
For best performance and continued durability,

please take note of the following key points:

1. Use only premium grade fuel 91 octane or

higher (R+M/2).

2. The engine must have stock compression

ratio.

3. If the engine has been modified in any way,

check with Paxton prior to using this prod-

uct.

4. Always listen for any sign of detonation

(pinging) and discontinue hard use (no

boost) until problem is resolved.

5. Perform an oil and filter change upon com-

pletion of this installation and prior to test

driving your vehicle. Thereafter, always use a

high grade SF rated engine oil or a high

quality synthetic, and change the oil and fil-

ter every 3,000 miles or less. Never attempt

to extend the oil change interval beyond

3,000 miles, regardless of oil manufacturer's

claims as potential damage to the super-

charger may result.

6. Before beginning installation, replace all

spark plugs that are older than 1 year or

10,000 miles with original heat range plugs

as specified by the manufacturer and reset

timing to factory specifications (follow the

procedures indicated within the factory

repair manual and/or as indicated on the

factory underhood emissions tag). Do not

use platinum spark plugs unless they are

original equipment. Change spark plugs at

least every 15,000 miles and spark plug

wires at least every 50,000 miles.

RECOMMENDED TOOLS

FOR INSTALLATION:

1. Factory Repair Manual
2. 3/8" Socket and Drive Set: SAE & Metric
3. 1/2" Socket and Drive Set: SAE & Metric
4. 3/8" NPT Tap and Handle
5. Adjustable Wrench
6. Open End Wrenches: Metric and Standard
7. Center Punch and a 5/8" Tapered Punch
8. Springlock 3/8" and 5/8”Fuel Fitting

Disconnect Tool

9. 5 Quarts SH/CF Rated Quality Engine Oil
10. Oil Filter and Wrench
11. Flat #2 Screwdriver
12. Phillips #2 Screwdriver
13. Heavy Grease
14. Silicone Sealer
15. Drill Motor
16. 1/8", 3/16", 27/64" Drill Bits
17. Wire Strippers and Crimpers
18. Utility Knife
19. Power Steering Pulley/Puller & Installer
20. Pliers

If your vehicle has in excess of 10,000 miles

since its last spark plug change, then you will

also need:

21. Spark Plug Socket
22. NEW Spark Plugs

2002 Dodge Hemi

RECOMMENDED TOOLS FOR INSTALLATION