Paxton Superchargers 5.7L Dodge Hemi - Manual (Page 10)

2
P/N: 4809650
©2004 Paxton Automotive
All Rights Reserved, Intl. Copr. Secured
11NOV04 v1.0 03DodgeHemi(4809650v1.0)
G. Unclip the 4 clips that retain the top portion
of the factory air filter housing and set the
housing and rubber duct aside it will not be
reused.
H. Remove the air filter and lift up on the lower
portion of the factory air filter housing and
remove it from the air filter support bracket
set the lower portion of the housing aside it
will not be reused. (See Fig. 1-e.)
Fig. 1-e
Fig. 1-f
Fig. 1-g
Fig. 1-h
I. Locate the intake air temperature sensor on
the passenger side of the large plastic throt-
tle body enclosure. Disconnect the wire har-
ness plug, remove the sensor using a twist-
ing motion and set the sensor aside to be
reinstalled in a later step of the installation.
J. Remove the two 10mm headed bolts secur-
ing the plastic throttle body enclosure.
Remove the rubber hose going to the oil fill
neck and remove the enclosure and set aside
it will not be reused. (See Fig. 1-f.)
K. Remove the factory orange silicone ring
from the throttle body and set aside. Remove
the accessory drive belt. (See Fig. 1-g.)
L. Using a 8mm socket, remove the eight fac-
tory screws securing the underside of the
passenger side inner fender well cover.
Remove the four 13mm head screws secur-
ing the air filter enclosure bracket to the
fender and remove the bracket it will not be
reused. Reinstall the inner fender well cover
using the factory hardware. (See Fig. 1-h.)
10mm HEADED BOLTS
CRANKCASE BREATHER
HOSE