Paxton Superchargers 5.7L Dodge Hemi - Manual (Page 37)

1
P/N: 4809650
©2004 Paxton Automotive
All Rights Reserved, Intl. Copr. Secured
11NOV04 v1.0 03DodgeHemi(4809650v1.0)
Section 14
WATER PUMP WIRING
14. WATER PUMP WIRING
A. Using a supplied sheet metal screw, attach
the supplied relay to the driver’s side radia-
tor core support per Fig. 14-a.
Fig. 14-a
B. Attach a supplied ring terminal to the
ground wire (black) on terminal 86 of the
supplied relay; attach a supplied ring termi-
nal to the relay mounting screw.
C. Route the red wire on terminal 87 down and
along the backside of the front bumper and
connect to the green wire using the supplied
butt connector at the previously installed
water pump. Use the supplied wire ties to
secure as necessary.
D. Route the yellow wire from terminal 85 and
the ???
E. Route the red wire from terminal 30 on the
relay into the engine compartment and
attach a supplied ring terminal to the wire
end. The ring terminal must be connected to
a constant battery power source. Remove the
cover from the remote battery lug next to the
engine compartment’s fuse/relay center.
Secure the ring terminal to this lug using
factory hardware and use wire ties to secure
the wire as needed away from sharp or hot
objects.
F. With the key on, make sure the charge cool-
er water pump is operating and that water is
flowing through the surge tank. Fill the
surge tank if necessary with a 50/50 coolant/
water mix. If the water is not flowing,
remove the charge cooler supply hose and
lower until water flows out of the hose. If
necessary, provide light suction to the hose
to help prime the pump. Verify water flow.
Do not let the pump run for extended peri-
ods (30 seconds or more) without water
flow. Fill the charge cooler tank until the
level stabilizes.
14. WATER PUMP WIRING