Ipod® playback – Denon AVR-2808CI User Manual
Page 50
NOTE
• Depending on the type of iPod and the software version, some
functions may not operate.
• DENON will accept no responsibility whatsoever for any loss of iPod
data.
Listening to Music
1
Use
ui
to select the menu, then press
ENTER
or
p
to select the music fi le to be played.
2
Press
ENTER
.
Playback starts.
Stopping playback temporarily
During playback, press
ENTER
or
[1]
.
Press again to resume playback.
Fast-forwarding or fast-reversing
During playback, either press and hold
u
(to fast-reverse) or
i
(to
fast-forward), or press
[6]
or
[7]
.
To cue to the beginning of a track
During playback, either press
u
(to cue to the previous track) or
i
(to
cue to the next track), or press
[8]
or
[9]
.
To stop
During playback, either press and hold
ENTER
or press
[2]
.
Playing repeatedly
Press
[CHANNEL –]
.
[Selectable items]
All One Off
MENU
: ”Input Setup” – ”iPod” – “Repeat”
(vpage 35)
• With the default settings, the iPod can be used connected to the VCR
(iPod) connector.
• Press
standby mode before disconnecting the iPod. Also switch the input
source to one to which the menu “iPod dock” is not assigned before
disconnecting the iPod.
iPod® Playback
The music on an iPod can be played by using the Control Dock for
iPod (ASD-1R, ASD-3N or ASD-3W, sold separately).
The operation can also be performed using the buttons on the main
unit or remote control unit while watching the menus.
iPod is a trademark of Apple Computer, Inc., registered in
the U.S. and other countries.
b
The iPod may only be used to copy or play contents that are not
copyrighted or contents for which copying or playback is legally
permitted for your private use as an individual. Be sure to comply
with applicable copyright legislation.
1
Make the necessary preparations.
q
Set the iPod in the DENON Control Dock for iPod.
(vSee the Control Dock for iPod’s operating instructions.)
w
Assign the Control Dock for iPod’s input.
MENU
: ”Input Setup”
–
“Assign”
–
”iPod dock”
(vpage 36)
2
Either turn
or press
[iPod]
(AMP
mode) to select the input source assigned in step 1-w
above.
(iPod screen)
b
If the screens above are not displayed, the iPod may not be
properly connected. Try connecting again.
3
To operate using the main remote control unit, set the
remote control unit to the iPod mode.
(vpage 51 “Remote Control Unit Operations”)
OK to disconnect
Basic Operation
About the button names in these explanations
< > : Buttons on the main unit
[ ]
: Buttons on the remote control unit
Button name only:
Buttons on the main unit and remote control unit
ENTER
INPUT MODE
uiop
uiop
[SEARCH]
[ iPod]
[iPod]
[CHANNEL + –]
ENTER
INPUT MODE
[8],[9],
[6],[7],
[1],[2]
Get
ting Star
ted
Connections
Set
up
Pla
ybac
k
Remot
e Contr
ol
Multi-Zone
Inf
or
mation
Tr
oubleshooting
(AMP mode)
AVR2808CIEU.indd 50
2007/06/20 8:58:22