KBC Networks MPEG4 Decoder - Manual (Page 21)

Decoder User Manual
Manual-MPEG4_DECA-Rev1206
Copyright © KBC Networks 2011
Page 21 of 29 www.kbcnetworks.com
3.2.6 Firmware
When “Firmware” is clicked, the interface will ask if you want to upgrade the
firmware. Clicking “Apply” will bring the user to the screen where the firmware files
will be input. Clicking “Apply” will not upgrade the firmware immediately as the
correct files must be found in order to upload. Clicking “Reset” will return to the
main menu. To upgrade, click “Apply” then click “Browse” to locate the two needed
files for firmware upgrade. You will require the images and md5 files in order to
successfully upgrade firmware. These files must be obtained from KBC and saved in
an accessible place to locate from the “Browse” button. Browse and locate then click
“Apply”. When the firmware begins to upload to the decoder, the LAN port activity
LED will flash rapidly and the decoder will display a process bar to indicate the
completion procedure. Do not turn off the decoder or disconnect the Ethernet cable
until after the GUI shows the process bar at 100%. The unit will then automatically
go through the reboot process. Expect the power LED to turn off and then re-
illuminate up to a minute later.
3.2.7 Factory Default
The decoder can be returned to factory defaults completely or you can save its
WAN/LAN & other IP Settings. Click “Apply” to reset all (or all but WAN and HTTP
Settings if appropriate box is clicked) configurations to factory defaults.
3.2.7.1 Factory Default Configurations
If all settings are returned to default, the new configurations are as follows:
 LAN/WAN IP Address 192.168.0.200
 LAN/WAN Subnet Mask 255.255.255.0
 Gateway IP Address 192.168.0.254
 GUI Access User Account ID admin
 GUI Access Password 123456
 Audio In Disabled
 Data Protocol Selection (Dip Switch) RS-422/485
 TCP/IP Connect 192.168.0.100
 Connect ID admin
 Connect Password 123456
 Baud Rate 9600 BPS
 Serial Port Control 8,N,1