Dataman 848Pro2 - Manual (Page 32)

32
If search result is “No Programmers found”, please try to turn off Stand-Alone
programmer, by menu “File / Shut down computer”, turn off the power button on the
back side of programmer, wait for 15 seconds or more and start programmer again. If
the search result is still “No Programmers found”, please refer to troubleshooting
documentation.
Programmer / Connect Sites
Menu command starts control applications for all available programmer sites. The
“Connecting Sites“ indicator is displayed during connecting of sites. Additional
information about site connection progress is displayed for each site in the Status panel
on the main screen.
Programmer sites are numbered from #1 to #8 in direction of physical placing of sites
from left to right.
When connection process is complete, indicator “Connecting Sites” will be hidden. The
Status panel will contain information about each site. Following status information are
most common:
Ready means the programmer site is connected and ready to start any
operation
Present special status of connected site, means the site is connected but it is
also not selected (checked in dialog Select sites). User selected device
or project operations will not run on Present (unselected) sites. User
can set site selection in dialog 'Select sites' accessible by menu
command 'Programmer / Select Enabled sites'.
No project file is loaded – means the site is successfully connected but no project
file is loaded. It also means that no device is selected. The
recommended action is “Load project“.
other text describes current status of site(s)
Programmer / Disconnect Sites
Menu command is used to disconnect all programmer sites and close Programmer sites
control applications. The command will apply only if no device operation is currently
running on any of connected sites. The command does not close main control program.
Also Stand-Alone programmer computer remains running.
Programmer / Automatic YES!...
Command displays dialog “Site settings” with Automatic YES! options.
Three modes of Automatic YES! function are available:
On Automatic YES! Is always On
Off Automatic YES! Is always Off
Use Project settings Automatic YES! setting depends on relevant settings
stored in project file