Dataman 848Pro2 - Manual (Page 11)

11
Technical specification
Specification (DATAMAN-848PRO2 multiprogramming
system)
8x universal programming module (8x 48-pin DIL ZIF sockets and 8x ISP connector)
operation result LEDs, LED power
line power input 100-240VAC/60W max.
banana jack for ESD wrist straps connection
banana jack for connection to ground
Specification (PC system inside of programmer)
Microsoft Windows Embedded 8.1 Industry Pro operation system
CPU Intel Core i5 -2.9GHz
4 GB RAM
500 GB HDD
Specification (valid for each programming module)
HARDWARE
Base unit, DACs
USB 2.0 high-speed compatible port, up to 480 Mbit/s transfer rate
on-board intelligence: powerful microprocessor and FPGA based state machine
three D/A converters for VCCP, VPP1, and VPP2, controllable rise and fall time
VCCP range 0..8V/1A
VPP1, VPP2 range 0..26V/1A
autocalibration/selftest
selftest capability
Socket, pindriver
48-pin DIL ZIF (Zero Insertion Force) socket accepts both 300/600 mil devices up to
48-pin
pindrivers: 48 universal
VCCP / VPP1 / VPP2 can be connected to each pin
perfect ground for each pin
FPGA based TTL driver provides H, L, CLK, pull-up, pull-down on all pindriver pins
analog pindriver output level selectable from 1.8 V up to 26V
current limitation, overcurrent shutdown, power failure shutdown
ESD protection on each pin of socket (IEC1000-4-2: 15kV air, 8kV contact)
continuity test: each pin is tested before every programming operation
ISP connector
20-pin male type with miss insertion lock
6 TTL pindrivers, provides H, L, CLK, pull-up, pull-down; level H selectable from 1.8V
up to 5V to handle all (low-voltage including) devices.
1x VCCP voltage (range 2V..7V/100mA) , can be applied to two pins
programmed chip voltage (VCCP) with both source/sink capability and voltage sense
1x VPP voltage (range 2V..25V/50mA)