Dataman 848Pro2 - Manual (Page 22)

22
Note: Menu Device operation options and depend on the selected
device.
9. Save project: click on and select destination folder, write a description of
project etc.
You can make a project on other DATAMAN programmers (DATAMAN-48PRO2…) too.
For more details see Help for PG4UW or “Dataman PRO series_manual”. The latest
manual may be found at
www.dataman.com .
Production mode
Warning: External display, keyboard and mouse not needed in this mode.
This part of the software is focused on the easy monitoring of high-volume production
operations via graphical control unit with touch screen.
The user can control the following basic operations:
load project file
connect/disconnect programmer sites
select desired device master operation (blank check, verify, program, erase)
start/stop device operation on connected programmer sites
set some advanced options to customize available settings, for example Automatic
YES! Function
create Job report
create Problem report
copy project file(s) from external drive (for example from network drive, USB key
etc.) to the standalone's local [Projects] folder
see the progress of device operation, including statistics information, serialization...
Step by step instruction
Starting Stand-Alone multiprogramming system
1. Check if the power switch placed at back side of programmer, near power supply
connector is on position '0'.
2. Plug the power cord into the programmer power supply connector and turn on the
programmer by the power switch placed at back side of programmer.
3. When the built-in computer is turned on the operating system will start booting-
up, cooling fans should start to work, and “Please Wait” screen should be
displayed on graphical control unit.
4. Starting of the operating system can take some time, normally this time is shorter
than 1 minute.
5. After the operating system has successfully started, the PG4UWMC control
program will start automatically. When the PG4UWMC is ready to work the
“Welcome screen” is displayed on graphical control unit.
6. Click the OK button on “Welcome” screen to continue. The main screen with
menus and Status panel should appear on graphical control unit.