d&b D12 Software User Manual

Page 23

Edit Password

MASTE

LMNOPQ

STUVWXYZ

MASTER

ABCDEFGH

Edit Password

1. Selecting "Password" enters the "Edit Password" mode and the

cursor is positioned at the beginning of the "Password".

2. Pressing the encoder enters edit mode. The pointer ( ) indicates the

entry position for new or edited characters. The selection of
characters (Capital letters) is displayed in the bottom line.

3. Each character can be highlighted by turning the encoder. Turning

left moves the cursor to the start of the list (A ⇐), turning right to the
end of the list (⇒ Z).

4. When you press the encoder, the highlighted letter is entered into

the password line and the pointer advances by one space.

5. Repeat steps 1 to 4 until the complete password is entered.
6. Exit edit mode by moving the cursor to the return sign ( ) and

pressing the encoder.

Notes:

An existing entry can be completed using the return sign at any position.
Succeeding letters are deleted automatically.

Single characters can be kept by simply pressing the encoder and the
pointer advances by one space after each entry.

The editing position can be scrolled through the characters by pressing
and turning the encoder simultaneously.

Edit Password

MASTER

Ok Cancel

Ok
Selecting "Ok" and pressing the encoder confirms the new setting and
exits the submenu "Password".

Cancel (⇒

⇒

Back

)

Exits the submenu leaving the previous password installed.

Unlocking the device
An attempt to change the status of the device in "Lock" mode is met by
the message "Unlock: Press knob 2s" being briefly displayed. Unlock the
device as follows:

Press 2s
Press and hold the encoder for a minimum of 2 seconds until the
message "Unlock: Press knob 2s" disappears from the first line of the
LCD.

Password
Press and hold the encoder for a minimum of 2 seconds until "Please
Enter Password" is displayed. The password is entered as described
above under "Password". An incorrectly entered password will revert
the device to the screen selected for "Lock" mode.

Notes:

If the password has been lost, a protected D12 can be released by a
System Reset (See Section 2.6 System Reset on page 33).

D12 Software manual (Firmware V2.x.x)

(5.5 EN)

Page 23 of 36