d&b D12 Software User Manual
Page 11
On the right hand side the software version of the selected speaker
configuration is displayed.
A change of the loudspeaker type has to be confirmed. This can be
done by selecting "Ok" or "+Clear". Both are marked by a flashing
question mark (?).
Ok
Selecting "Ok" and pushing the encoder confirms the configuration and
exits the submenu "Speaker Selection".
+Clear
Selecting "+Clear" and pushing the encoder confirms the configuration
and exits the submenu "Speaker Selection" and clears the user settings
of this channel. The following operations are executed:
- Reset of configuration switches (Filter_1, Filter_2, Filter_3)
- Reset of Delay (the selected unit will be kept)
- Reset of all EQ settings
- Load and Input Monitoring will be set to “off”
- The respective channel will be muted
Cancel (⇒
⇒
⇒
⇒
Back
)
Exits the submenu "Speaker Selection" while the previous configuration
remains active.
Filter_1, Filter_2, Filter_3
Speaker Q7
CUT on
HFA on
CPL off
The name of the filter is displayed on the left of the LCD followed by its
status or value and a pictogram or graphic representation of the filter's
frequency response.
The type of filters available depends on the selected loudspeaker
configuration.
The display [---] indicates that the respective filter is not available for the
loudspeaker type selected.
on/off
The schematic change in response is indicated by the pictogram.
[Value] (Filter_3)
"Filter_3" can be set to different values. The schematic change in
response is indicated by the pictogram.
Filter_1
Filter_2
Filter_3
Configuration of crossover frequencies
for TOP/SUB,
e.g. CUT, 100 Hz, Infra, +B2
Compensation towards listening
distance, e.g. HFA, HFC.
CSA (Cardiod Subwoofer Array)
Array-EQ (compensation of coupling
effects) ⇒ CPL
Range:
–9 dB ... 0 dB Cut (Lo shelf)
0 dB ... +5 dB Boost (65 Hz, Bell)
Tab. 2: Settings Filter_1, _2, _3
Notes:
A detailed description of the filters available for each
loudspeaker is given in the respective loudspeaker
manuals.
A detailed description of the CSA function (Cardioid
Subwoofer Array) is given in the technical information
TI 330 which can be downloaded from the d&b website at
.
D12 Software manual (Firmware V2.x.x)
(5.5 EN)
Page 11 of 36