d&b D12 Software - Manual (Page 14)

Impedance Z
The impedance of the loudspeaker(s) presented to the output of the
D12, displayed only as a numeric value in ohms. The value is measured
with the actual output signal and may therefore vary with its spectral
content. The measurement range reaches from 0 ohms (short circuit) to
255 ohms (open loop, I = 0, Z ⇒ ∞). When the signal is too low the
maximum of 255 ohms is displayed.
Power
The actual output power, displayed as bar graph and as a numeric
value in watts, the colon [B] acts as a peak hold for 1 s.
Channel Name
Channel Name
Channel A
Ok Cancel
Channel Name
MyChanne l
e f g h i j k l m n o p q r s t
MyChannel
STUVWXYZÄÖÜ abcdefgh
Channel Name
Channel Name
Enables the assignment or editing of the channel name (maximum 15
characters):
1. Selecting "Channel Name" enters the submenu and the cursor is
positioned at the beginning of the "Channel Name". The factory
default setting is "Channel" followed by the selected channel (A or
B).
2. Pressing the encoder enters edit mode. The pointer, ( ), indicates
the entry position for new or edited characters. A variety of
characters (e.g. capital and lower case letters, numbers 0-9 and
special characters) is displayed in the bottom line.
3. Each character can be highlighted by turning the encoder. Turning
left moves the cursor to the start of the list (A ⇐), turning right to the
end of the list (⇒ @).
4. When you press the encoder, the highlighted letter is entered into
the upper line and the pointer advances by one space.
5. Repeat steps 1 to 4 until the complete device name is entered.
6. Exit edit mode by moving the cursor to the return sign ( ) and
pressing the encoder.
Notes: An existing entry can be completed using the return sign at any position.
Succeeding letters are deleted automatically.
Single characters can be kept by simply pressing the encoder and the
pointer advances by one space after each entry.
The editing position can be scrolled through the characters by pressing
and turning the encoder simultaneously.
Channel Name
MyChannel
Ok Cancel
Ok
Selecting "Ok" and pressing the encoder confirms the new setting and
exits the submenu "Channel name".
Cancel (⇒ ⇒ ⇒ ⇒ Back )
Exits the submenu leaving the previous channel name installed.
D12 Software manual (Firmware V2.x.x) (5.5 EN) Page 14 of 36