d&b D12 Software - Manual (Page 19)

Level
Level of the frequency generator in dBu covering a 63.5 dB range from
–57.5 dB to +6 dB in 0.5 dB steps. The level value corresponds to the
level at the controller signal input. The actual output voltage depends on
the channel input gain, the frequency dependent gain of the selected
loudspeaker configuration and EQ settings if used.
Frequency
Frequency adjustable in the range of 1 Hz to 20 kHz in 1 Hz steps.
Link A»B
Link A B off
D12 Stage right
Q7
-3.0dB -3.0dB
CUT HFA EQ 0.01 CSA EQ
Q-SUB
+0.0dB
100
In "Dual channel" and "Mix Top/Sub" mode EQ and/or Delay settings
of both channels can be linked using the "Link A»B" function. These
functions are then controlled in the Channel A menu, in the Channel B
menu the linked functions cannot be edited.
On the "Main screen" the "Link A»B" function is indicated by altering
the center line to arrows as shown in the graphic opposite.
Selecting "Link A»B" and pushing the encoder allows the setting of the
following modes:
off: Both controller channels are operated independently.
EQ: The EQ function of controller Channel B is linked to
controller Channel A.
Delay: The Delay function of controller Channel B is linked to
controller Channel A.
EQ+Delay: Both the EQ and Delay function of controller Channel
B are linked to controller Channel A.
Notes: In "2-Way Active mode" the "Link A»B" is used
permanently to link the channels and cannot be modified.
In this mode also the "MUTE A" and the "MUTE B"
switches are linked. Therefore the device can be
muted/unmuted by either the "MUTE A" or the "MUTE B"
switch. After leaving "2-Way Active mode" the "Link A»B"
will be set to "off".
D12 Software manual (Firmware V2.x.x) (5.5 EN) Page 19 of 36