d&b D12 Software - Manual (Page 10)

Output (Output routing)
Settings Id0.01
Back
Input
analog
Output Dual channel
Selecting "Output" and pushing the encoder allows the setting of the
following output configurations
1. Dual channel
2. Mix Top/Sub
3. 2-Way Active
Depending on the selection the corresponding pin assignment of the
loudspeaker output connectors will be set automatically.
Note: After a change of the output configuration the D12
outputs are muted. Use the respective MUTE A or MUTE B
switches to unmute it.
A detailed description of the D12 output configurations is
given in the D12 Hardware manual, which is also supplied
with the D12 Amplifier.
Input analog
Output Dual channel
Ch A Q7
Ch B Q-SUB B
A
A
Channel A (B)
For both Channel A and B the functions and submenus (menu structure)
are similar. Therefore "Channel B" is stated in brackets (B).
Selecting "Channel A (B)" and pushing the encoder enters the submenu
"Setup Channel A (B)".
Setup Channel A
Back
Source
Input A
Speaker Q7
Source Input A+B
Ch A Q7
Ch B Q-SUB
A
B A A
Setup Channel A (B)
Source (Input routing)
Within the submenus "Channel A" and "Channel B" the input source for
the respective channel can be selected.
Selecting "Source" and pushing the encoder allows the setting of the
following routings:
Input A:
The respective channel is fed from input A.
Input B: The respective channel is fed from input B.
Input A+B: The respective channel is fed from input A+B.
(Input A+B are summed with a 6 dB attenuation)
The status of the selected input source is displayed in the settings menu
as shown in the graphics opposite.
Notes on the digital AES/EBU input ⇒ ⇒ ⇒ ⇒ Input routing:
According to the AES standard (AES3-2003 - Stereophonic mode) the
AES channels are assigned to the D12 controller as follows:
D12 Channel A: AES left or A channel (subframe 1)
D12 Channel B: AES right or B channel (subframe 2)
Speaker Q7 Speaker
Speaker Selection A
Q7 V1.01
Ok? +Clear? Cancel
Speaker Selection
Selecting "Speaker" and pushing the encoder enters the submenu
"Speaker Selection" which enables the selection of loudspeaker setups
for applicable d&b loudspeakers, depending on the selected output
mode.
D12 Software manual (Firmware V2.x.x) (5.5 EN) Page 10 of 36