d&b D12 Software - Manual (Page 22)

RIB/RS232: remote control via RS232 and the SERVICE connector
of the D12. (indicated as "
RIB 2 " in the main screen)
dbCAN: remote control via dbCAN (CAN-Bus)/ROPE C.
In 2-Way Active mode indicated as "
CAN " and the
"dbCAN Id", e.g. 7.63 in the main screen.
In Dual channel or Mix Top/Sub mode indicated by
the "dbCAN Id", e.g.
7.63 in the main screen.
Sub net 0 to 7
Device Id 01 to 63
dbCAN Id 7 . 01
dbCAN Id 0 . 01
dbCAN Id 7. 63
dbCAN Id 7. 01
dbCAN Id
Setting the "dbCAN identifiers [n].[nn]". The first digit represents the
CAN subnet. Eight subnets can be defined (values 0 to 7). Using the two
digit device ID for each subnet 63 devices can be defined (values 01 to
63).
Lock Press 2s Lock
Selecting "Lock" and pressing the encoder enters the submenu.
Lock
Back
Lock now
Mode Press 2s
D12 Stage right
J12
-3.0dB -3.0dB
HFC LFC EQ 0.01
Active
0.3ms D
CAN C -5
Lock now
Pressing the encoder switches the device into "Lock" mode according to
the mode selected below and exits the submenu "Lock". In 2-Way
Active Mode a locked device is indicated by "
" in the Main screen.
Mode
Selecting "Mode" and pressing the encoder toggles between two
options to protect the device against unintentional operation.
Press 2s: prevents accidental operation by locking the front
panel controls.
Password: password protection preventing operation by
unauthorized persons.
Show Main Screen Show
Selecting "Show" and pressing the encoder allows two different screens
to be displayed when the device is locked.
Main Screen: switch to the "Main screen".
Levels Screen: switch to the "Levels screen".
Password Selecting "Password" and pressing the encoder enters the submenu
"Edit Password".
Edit Password
DBAUDIO
Ok Cancel
Edit Password
Enables the input of a new password or editing of an existing password
(maximum 7 characters).
Note: Factory (default) password DBAUDIO.
D12 Software manual (Firmware V2.x.x) (5.5 EN) Page 22 of 36