CONTA-CLIP SMS-MULTI I/O - Manual (Page 12)

SMS-MULTI-IO
- 11 -
Connect the programming cable (artnr. 16062.2, sold separately, Please contact Conta-Clip for
further information) to the audio plug, and the other end to a USB port on the PC.
3.5 3.5 3.5 3.5
LED description
LED description LED description LED description
3.5.1 3.5.1 3.5.1 3.5.1 Module status indication
Module status indication Module status indication Module status indication
The Led ‘Run’ indicates module activity:
•
Flash = searching for modem
•
ON = power ON and modem detected
•
OFF = no power / no CPU activity
The Led ‘Com’ indicates network activity:
•
green ON = connected to GSM network
•
green Flash = roaming GSM network
•
green OFF = not connected to GSM network
The Led ‘Busy’ indicates modem activity:
•
ON = modem currently busy
• OFF = no modem activity
After sending new parameters to the module it will perform a reset. During this time the Com
network activity LED lights up red for 5 seconds.
3.5.2
3.5.2 3.5.2 3.5.2 IO indication
IO indication IO indication IO indication
• For each Digital Output a Led lights up when the relay is activated.
• The brightness of the Analog Output Leds varies along with the output voltage.
•
The Universal Input Leds light up when:
•
When set as digital input : the input is active (1)
•
When set as analog input or RTD : a top or bottom threshold is reached