Altera Dynamic Calibrated On-Chip Termination - Manual (Page 7)

Chapter 2: Parameter Settings 2–3
Command Line Interface Parameters
February 2012 Altera Corporation Dynamic Calibrated On-Chip Termination (ALTOCT) Megafunction
User Guide
Command Line Interface Parameters
Expert users can choose to instantiate and parameterize the megafunction through the
command-line interface using the clear box generator command. This method
requires you to have command-line scripting knowledge.
f
For more information about using the clear box generator, refer to the Introduction to
Megafunctions User Guide .
Table 2–2 lists the parameters for the ALTOCT megafunction.
Table 2–2. ALTOCT Megafunction Parameters
Parameter Name Type Required Description
ENABLE_PARALLEL_TERMINATION String Yes
Enables the RT State Machine. Values are TRUE and
FALSE. If omitted, value is FALSE.
OCT_BLOCK_NUMBER Integer Yes
The number of OCT blocks in the design. Values are
integer 1 to 10.
LPM_HINT String No
Allows you to specify Altera-specific parameters in
VHDL Design Files (.vhd). The default value is UNUSED.
LPM_TYPE String No
Identifies the library of parameterized modules (LPM)
entity name in VHDL Design Files (.vhd).
INTENDED_DEVICE_FAMILY String No
This parameter is used for modeling and behavioral
simulation purposes. Create the ALTOCT megafunction
with the MegaWizard Plug-In Manager to get the value
for this parameter.