Altera Dynamic Calibrated On-Chip Termination - Manual (Page 17)

February 2012 Altera Corporation Dynamic Calibrated On-Chip Termination (ALTOCT) Megafunction
User Guide
Additional Information
This chapter provides additional information about the document and Altera.
Document Revision History
The following table lists the revision history for this document.
Date Version Changes
February 2012 3.0
Updated the following sections:
■ “Device Support” section
■ “MegaWizard Parameter Settings” section.
November 2008 2.0
■ Updated the following sections:
■ “Device Support” section
■ “Features” section
■ “Functional Description” chapter
■ “Design Example: Series Calibration for Four Calibration Blocks Using Stratix III
Device”
section
■ “Functional Simulation in the ModelSim-Altera Software” section
■ “This chapter describes the functional description and the design examples of the
ALTOCT megafunction. This section also includes the ports descriptions of the ALTOCT
megafunction. You can use the ports to customize the ALTOCT megafunction
according to your application.”
section
■ “How to Contact Altera” section
■ Removed the following sections:
■ “Resource Utilization & Performance” section
■ “Software and System Requirements” section
■ “Instantiating Megafunctions in HDL Code” section
■ “Identifying a Megafunction after Compilation” section
■ “SignalTap II Embedded Logic Analyzer” section
■ Removed all screenshots in the “This section describes the parameter settings for the
ALTOCT megafunction.You can parameterize the megafunction using the MegaWizard ™
Plug-In Manager or the command-line interface (CLI). Altera recommends that you
configure the megafunctions using the MegaWizard Plug-In Manager.”
section
■ Reorganized the “This section describes the parameter settings for the ALTOCT
megafunction.You can parameterize the megafunction using the MegaWizard ™ Plug-In
Manager or the command-line interface (CLI). Altera recommends that you configure the
megafunctions using the MegaWizard Plug-In Manager.”
section into table format.
■ Renamed “About this User Guide” section to “Additional Information” and moved the
section to the end of the user guide.
December 2006 1.0 Initial release