Datalogic Scanning 4420 - Manual (Page 69)

Firmware Update Utility
Product Reference Guide 3-9
• Click Cancel to quit Setup and close any programs you have run-
ning.
• Click Next to continue the Setup.
3. Follow the onscreen instructions to complete the installation.
Updating the Falcon Firmware
After copying the firmware image to the host PC ("Retrieving a Firmware
Image Update" on page
3-8 ) and installing FUU ("Installing FUU on the Host
PC" on page 3-8 ), you can upgrade the firmware on your Falcon.
1. Go to Start > Programs > Firmware Update Utility > Firmware Update Utility .
2. Verify that ActiveSync is selected from the Communicate Using pull-
down list.
3. Click browse ( ... ) and navigate to the location where you saved the
firmware file for your terminal.
4. Select the current * .img file and click Open .
The following steps require that you have already established an ActiveSync con-
nection between the host computer and the Falcon. To establish an ActiveSync
connection with the Falcon, refer to "Installing & Setting Up Microsoft Active-
Sync" on page 4-1 and "Using ActiveSync" on page 4-6, for more information on
ActiveSync.