Datalogic Scanning 4420 - Manual (Page 18)

Configuring the Falcon
2-2 Falcon
®
4400 Series with Windows
®
CE
• "Regional Settings" on page 2-31
• "Remove Programs" on page 2-32
• "Storage Properties" on page 2-32
• "Stylus Calibration" on page 2-33
• "System Properties" on page 2-35
• "Volume and Sounds" on page 2-38
• "Wi-FI" on page 2-39
Backlight
To change the Backlight settings, complete the following steps:
1. Select Start > Settings > Control Panel > Backlight to open the Backlight
control panel. Some Falcon keypads also provide keyboard shortcuts
to launch the
Backlight control panel:
• On the 26-key model press: + ( ).
• On the 48-key model press: + ( ).
• On the 52-key model press: +< . > .
2. On the Brightness tab (refer to Figure 2-1 ), select one of the five (5)
radio buttons to adjust the brightness to the desired setting by tapping
it with the stylus. You can also use the
and arrow keys
to adjust this setting.
3. Auto Power-Save dims (rather than turning off ) the backlight after 15
seconds of inactivity. This features does not change the behavior of
the Auto-Off Settings. (Refer to "Power Configuration" on
page
2-30 ).
Increasing backlight brightness can cause the battery pack to discharge at a faster
rate. The battery discharge rate decreases with a decrease in backlight usage.