Epson WorkForce 610 Series - Manual (Page 52)

52 Notices
■ Do not block or cover openings in the product case or insert objects through the slots.
■ Do not use aerosol products that contain flammable gases inside or around the
printer. Doing so may cause fire.
■ Do not press too hard on the document table when placing the originals.
■ Do not open the scanner section while the product is in use.
■ Do not touch the flat white cable inside the product, and be careful not to trap your
fingers when lowering the scanner.
■ Do not spill liquid on the product.
■ Adjust only those controls that are covered by the operating instructions. Except as
specifically explained in your documentation, do not attempt to service the product
yourself.
■ Unplug the product and refer servicing to qualified service personnel under the
following conditions: if the power cord or plug is damaged; if liquid has entered the
product; if the product has been dropped or the case damaged; if the product does not
operate normally or exhibits a distinct change in performance.
WARNING:
The cords included with this product contain chemicals, including lead, known to the
State of California to cause birth defects or other reproductive harm. Wash hands after
handling. (This notice is provided in accordance with Proposition 65 in Cal. Health &
Safety Code § 25249.5 and following.)
LCD Screen Safety
■ Use only a dry, soft cloth to clean the LCD screen. Do not use liquid or chemical
cleansers.
■ If the LCD screen is damaged, contact Epson. If the liquid crystal solution gets on
your hands, wash them thoroughly with soap and water. If the liquid crystal solution
gets into your eyes, flush them immediately with water. If discomfort or vision
problems remain after a thorough flushing, see a doctor immediately.
Ink Cartridge Safety Instructions
■ Keep ink cartridges out of the reach of children and do not drink the ink.
■ Be careful when you handle used ink cartridges; there may be ink remaining around
the ink supply port. If ink gets on your skin, wash it off with soap and water. If it gets
in your eyes, flush them immediately with water.
■ Do not put your hand inside the product or touch any cartridges during printing.