Waldorf Largo - Manual (Page 65)

Sound Parameter
65 Largo User´s Manual
reverb as if the signal were reflected by a uneven surface.
Settings above 100 change the room characteristic even
further.
Decay 0…127
Feedback of the reverb network. Recommended settings
are between 1/4 and half its range. Higher values create
audible ringing especially with small Size settings, which
don't correspond to any natural reverb response, but
might be used for simulations of spring or plate reverbs.
Maximum setting results in a very long reverb.
Low Damp 0…127
High pass filter in the feedback loop of the late reverb.
Determines how fast the room simulation dampens the
lower reverb frequencies. This phenomenon makes a
natural echo sound somewhat hollow. Higher values of
the Damping parameter mean more low frequencies will
be dampened.
Hi Damp 0…127
Low pass filter in the feedback loop of the late reverb.
Determines how fast the room simulation dampens the
higher reverb frequencies. This phenomenon makes a
natural echo sound somewhat hollow. Higher values of
the Damping parameter mean more high frequencies will
be dampened.
Low Cut 0…127
Determines the frequency where the lower frequency
parts are divided from the effect signal. This parameter
works in the same way as the highpass filter in the Largo´s
sound synthesis. A natural reverb doesn´t produce all
frequencies equally so the highpass cuts the lower
frequencies to produce a more realistic reverb effect.
High Cut 0…127
Determines the frequency where the higher frequency
parts are divided from the effect signal. This parameter
works in the same way as the lowpass filter in the Largo´s
sound synthesis. A natural reverb doesn´t produce all
frequencies equally so the lowpass cuts the higher
frequencies to produce a more realistic reverb effect.
Reverb Examples
All examples with Decay set between 0 and 40.
Room Size Shape
Oil Barrel 0-2 0-40