Waldorf Largo - Manual (Page 30)

Sound Parameter
Largo User´s Manual 30
[ To create a common pitch vibrato that is
controlled by the modwheel, set Osc Pitch Mod
Source
to LFO1*MW with Osc Pitch Mod
Amount set to around +20.
[ To create a sound whose pitch glides in, set Osc
Pitch Mod Source
to a decaying Envelope with
Osc Pitch Mod Amount set to around –25.
w
If you want to modulate the pitch of individual
oscillators, you can do so with the Modulation
Matrix
.
Osc Pitch Mod Amount -64...+63
Sets the amount of pitch modulation for all oscillators.
Positive amounts will raise the pitch when positive
modulation is applied, e.g. by pressing aftertouch on the
keyboard. Negative amounts will lower the pitch when
positive modulation is applied.
Mixer Section
Osc Level 0...127
Controls the volume of the selected Oscillator.
Osc Balance F1 64...mid...F2
63
Determines the ratio of the selected
Oscillator’s signal that is sent to the
inputs of Filter 1 and Filter 2. If set to
F1 64, the signal is sent to Filter 1
only. Higher values will increase the
amount of signal that feeds Filter 2
and decrease the amount of signal
that feeds Filter 1. If set to mid, both
filters will receive the same signal
level. If set to F2 63, the signal is sent
to Filter 2 only.
Ring Modulation
The following parameters refer to the ring modulator.
Ring Mod Level 0...127
Volume of the ring modulation between Oscillator 1 and
2. From a technical point of view ring modulation is the
multiplication of two oscillators’ signals. The result of this
operation is a waveform that contains the sums and the
differences of the source frequency components. Since the
ring modulation generates disharmonic components, it