Installation instructions – Vortech 2000-2008 Honda S2000 User Manual

Page 5

P/N: 4HS020-010

21OCT08 v4.0 S2000(4HS020-010v4.0)

2000-2008

HONDA S2000

Installation Instructions

Congratulations on selecting the best performing and best backed automotive

supercharger available today... the VORTECH® Supercharger!

Before beginning this installation, please read through this entire instruction booklet and the Street

Supercharger System Owner's Manual which includes the Automotive Limited Warranties Program and the

Warranty Registration form.
Vortech supercharger systems are performance improving devices. In most cases, increases in torque of

30-35% and horsepower of 35-45% can be expected with the boost levels specified by Vortech Engineering.

This product is intended for use on healthy, well maintained engines. Installation on a worn-out or damaged

engine is not recommended and may result in failure of the engine as well as the supercharger. Vortech

Engineering is not responsible for engine damage.

Installation on new vehicles will not harm or adversely affect the break-in period so long as factory break-in

procedures are followed.
For best performance and continued durability, please take note of the following key points:

1. Use only premium grade fuel 91 octane or higher (R+M/2).

2. The engine must have stock compression ratio.

3. If the engine has been modified in any way, check with Vortech prior to using this product.

4. Always listen for any sign of detonation (pinging) and discontinue hard use (no boost) until problem is

resolved.

5. Perform an oil and filter change upon completion of this installation and prior to test driving your vehicle.

Thereafter, always use a high grade engine oil or a high quality synthetic, and change the oil and filter

every 3,000 miles or less. Never attempt to extend the oil change interval beyond 3,000 miles, regard-

less of oil manufacturer's claims as potential damage to the supercharger may result.

6. Before beginning installation, replace all spark plugs that are older than 2 years or 20,000 miles with

original heat range plugs as specified by the manufacturer and retard timing from factory specifications

(follow the procedures indicated within the factory repair manual and/or as indicated on the factory

underhood emissions tag). Do not use platinum spark plugs unless they are original equipment. Change

spark plugs every at least 15,000 miles and spark plug wires at least every 50,000 miles.

TOOL & SUPPLY REQUIREMENTS:

• Factory Repair Manual

• 3/8" Socket and Drive Set: SAE & Metric

• 3/8” Swivel Head Ratchet

• 1/2" Socket and Drive Set: SAE & Metric

• 3/8" NPT Tap and Handle

• Adjustable Wrench

• Open End Wrenches: SAE & Metric

• Center Punch

• 5 Quarts SH/CF Rated Quality Engine Oil

• Oil Filter and Wrench

• Flat #2 Screwdriver

• Phillips #2 Screwdriver

• Heavy Grease

• Silicone Sealer

• Drill Motor

• 1/8", 3/16" Drill Bits

• Hex Key Wrench Set

• Wire Strippers and Crimpers

• Utility Knife

• Hand Held Grinder

• Blue Loctite

• 07JAB-001020A (Damper Tool) Available at Honda Dealer

• 07NAB-001040A (Damper Tool) Available at Honda Dealer

• Honda Bond (Sealer) Available at Honda Dealer

If your vehicle has in excess of 20,000 miles since its last spark plug change, then you will also need:

• Spark Plug Socket

• New Spark Plugs