Vortech 2000-2008 Honda S2000 User Manual

Page 37

P/N: 4HS020-010

21OCT08 v4.0 S2000(4HS020-010v4.0)

A. Locate the supplied charge cooler. Insert the

supplied 60 lb/hr fuel injector into the injector

base welded to the cooler discharge tube so

that the injector plug is facing away from the

injector base. (See Fig. 10-a.)

B. Insert the upper block over the injector.

Secure the upper injector block with the sup-

plied shoulder bolts.

C. Install the 1/8"NPT end of the supplied 90° fit-

ting into the upper injector block. Orient the

fitting so that it is pointing toward the back of

the car.

D. Connect the 90° end of the supplied steel

braided line to the -4 end on the installed

straight fitting in the fuel rail. Run the fuel line

toward the front of the car. Leave the open

end of the fuel line disconnected until the

charge cooler has been installed. (See Fig.

10-b.)

NOTE: lightly oil the o-rings on the injector for

easier installation.

NOTE: thread sealant is recommenced on all fit-

ting ends that have pipe threads.

10. SUPPLEMENTARY FUEL INjECTOR INSTALLATION (2004, 2005 MODELS ONLY)

Fig. 10-b

Fig. 10-a