Vortech 2000-2008 Honda S2000 - Manual (Page 14)

P/N: 4HS020-010
©2008 Vortech Engineering, LLC
All Rights Reserved, Intl. Copr. Secured
21OCT08 v4.0 S2000(4HS020-010v4.0)
2
1. PREPARATION/REMOVAL, Cont.
Fig. 1-f
Fig. 1-g
Fig. 1-h
Fig. 1-d
reMoVe ScrewS
L. Remove the factory idler (smooth) pulley and
hardware and set aside temporarily. (See Fig.
1-d)
M. Remove the two factory M8 x 1.25 screws
that attach the front corner of the cylinder
head to the engine front cove.r (See Fig. 1-f.)
N. Disconnect the wiring from the VTEC sole-
noid assembly. Remove the three screws
attaching the solenoid assembly to the side of
the cylinder head. (See Figs. 1-g,1-h.) Set the
VTEC solenoid assembly aside for mounting
in a later step. Make sure that the o-ring seal-
ing gasket does not get lost or damaged,
because it will be re-used in a later step.