Vortech 2000-2008 Honda S2000 - Manual (Page 31)

P/N: 4HS020-010
©2008 Vortech Engineering, LLC
All Rights Reserved, Intl. Copr. Secured
21OCT08 v4.0 S2000(4HS020-010v4.0)
19
3/8-16 x 3.5" SCREW / A WASHER
INSTALLED FROM THE BACKSIDE
THROUGH SUPPOR TE AND T PLA
Ø.875 x 1.858 SPACER AND INTO
UPPER SUPERCHARGERMOUNTING
BOSS (SPACER SANDWICHED BETWEEN
MAIN PLATE AND SUPPORT PLATE)
M6 1.0 x 80mm SCREWS
THROUGH VTEC SOLENOID
(NOT SHOWN), SUPERCHARGER
PLATE MOUNTING BLOCK
AND INTO CYLINDER HEAD)
CYLINDER HEAD
M10 x 1.25 x 50mm SCREW
WITH WASHER THROUGH
SUPERCHARGERPLATE MOUNTING
BLOCK AND INTO CYLINDER HEAD
SUPERCHARGERPLATE
MOUNTING BLOCK
M12 x 1.75 x 50 SCREW
FACTORY FIXED IDLER
PRE-INSTALLED 3/8-24
"PRESS NUT" INSERT (3 PLACES)
M12 WASHER
Ø1.0" x .549 SPACER
SUPERCHARGER
SUPPORT PLATE
FRONT FACE OF
ENGINE BLOCK
SUPERCHARGERBRACKET ASSEMBLY VIEW FROM PASSENGER SIDE –
VORTECHIDLERS AND SOME FASTENERSNOT SHOWN FOR CLARITY
(DASHED LINES REVEAL HIDDEN VIEWS)
LOWER SUPERCHARGERPLATE SPACER
(ROUND PROTRUSIONS TO BE INSTALLED
AGAINST THE FRONT COVER)
SUPERCHARGER
MOUNTING PLATE
M10 X 1.25 X 115 SCREW
THROUGH MAIN PLATE
Ø1.0 x 2.726 SPACER
FACTORY IDLER AND
INTO FACTORY
THREADED IDLER
MOUNTING HOLE
ON FRONT COVER
3/8-24 x 3.5" SCREWS
INSTALLED FROM THE
FRONT THROUGH MAIN
PLATE AND .875 x 1.858 Ø
SPACERS AND INTO
SUPPORT PLATE, SPACERS
SANDWICHED BETWEEN
MAIN PLATE AND SUPPORT
PLATE – 3 PLACES)
CENTER M12
SUPERCHARGERBOSS
3/8"
WASHER
Ø1.0" x 2.726
STEEL SPACER
M10
WASHER
M6 x 1.0 NUTS WITH WASHERS INSTALLED
ONTO STUDS PREVIOUSLYTHREADED
INTO FRONT OF ENGINE
1.858
2.726
.549
8. SUPERCHARGER MOUNTING BRACkET/PLATE INSTALLATION, cont’d.
Fig. 8-o