Vortech 2003-2004 Mustang Mach 1 User Manual

Page 41

P/N: 4FR020-010

23AUG04 86-93 4V Mus. Cobra(4FR v3.1)

P/N: 4FR020-010

23AUG04 86-93 4V Mus. Cobra(4FR v3.1)

13. FINAL CHECK

A. Reconnect the battery.
B. If your vehicle has gone over 20,000 miles since

its last spark plug change, you will need to

change the spark plugs now before test driving

the vehicle.

C. Check all fittings, nuts, bolts and clamps for

tightness. Pay particular attention to oil and fuel

lines around moving parts, sharp edges and

exhaust system parts. Make sure all wires and

lines are properly secured with clamps or tie

wraps.

D. Double check water pump pulley bolts for

tightness.

E. Check all fluid levels, making sure that your tank(s)

is/are filled with 91 octane or higher fuel before

commencing test drive.

F. Start the engine and allow to idle a few minutes,

then shut off.

G. Recheck to be sure that no hoses, wires, etc. are

near exhaust headers or moving parts and for

signs of any fluid leakage. (See Fig. 13-a.)

H. PLEASE TAKE SPECIAL NOTE: Operating the

vehicle without ALL the subassemblies completely

and properly installed may cause

FAILURE OF

MAJOR COMPONENTS.

I. Test drive the vehicle.
J. Read the STREET SUPERCHARGER SYSTEM

OWNER'S MANUAL AND RETURN THE

COMPLETED WARRANTY REGISTRATION

FORM within thirty (30) days of purchasing your

supercharger system .

Fig. 13-a

WARNING: Do not attempt to operate the vehicle

until ALL components are installed and

ALL operations are completed including

the final check.

NOTE: Once the ECM is recieved back from

Vortech with the ECM module installed,

reinstall the ECM into the vehicle. In some

cases, the extra height of the ECM mod-

ule will not allow the use of the factory

hold-down bracket. Reconnect the factory

harness and reinstall the factory kick panel.

This manual is related to the following products:

1999 & 2001 Ford 4.6L Mustang Cobra