Air conditioning line modification – Vortech 2003-2004 Mustang Mach 1 User Manual

Page 17

P/N: 4FR020-010

23AUG04 86-93 4V Mus. Cobra(4FR v3.1)

P/N: 4FR020-010

23AUG04 86-93 4V Mus. Cobra(4FR v3.1)

6. AIR CONDITIONING LINE MODIFICATION

A. Carefully bend the high pressure air conditioning

line (the line with the pressure port and cap) so

that the pressure port rotates down (for super-

charger inlet clearance). (See Fig. 6-a.)

Fig. 6-a

NOTE: Air conditioning lines are under high pres-

sure and the fluid is highly toxic. Therefore,

use extreme caution when bending the

line to avoid kinking or breaking the line.

Support the assembly as much as possible

while bending for clearance.

7. FAN RESISTOR RELOCATION (2001 and 2003-2004 Mach 1 models only)

A. 2003-2004 Mach 1: In order to remove the fan

resistor, you must unbolt the fan shroud from the

radiator. Pull the fans forward and remove the

resistor for the rear of the fans.

B. Cobra: Unsnap the resistor from the fanshroud

bracket. (See Fig. 7-b.) Pull the wire clips securing

the wires to the fan away from the shroud so that

the resistor can reach down. With the supplied

relocation bracket and sheet metal screws mount

the resistor (see Fig. 7-a).

C. SHROUD MODS: Trim the plastic which holds

the fan high/low resistor as shown in Fig. 7-b to

give clearance for the inlet duct.

Fig. 7-b

Fig. 7-a

FACTORY FAN

RESISTOR LOCATION

MODIFY SHROUD

AS SHOWN

This manual is related to the following products: