Vortech 2000-2003 Ford Focus Zetec/SVT - Manual (Page 33)

P/N: 4FJ020-010
©2004 Vortech Engineering, LLC
All Rights Reserved, Intl. Copr. Secured
19APR04 v3.0 Focus(4FJ v3.0)
21
Fig. 17-a
17. REFLASH COMPUTER, SVT Models Only
A. Reconnect the battery.
B. Locate the vehicles OBD2 connector located
in the lower left hand corner of the dash on
the drivers side of the vehicle. (See Fig 17-a.)
C. Attach the OBD2 connector from the Flash
tool that is provided in the kit to the vehicle’s
OBD2 port. (See Fig 17-b.) Make sure this
connector is seated all the way in the vehicles
OBD2 port. You do not want this connector
coming out during programming or damage
may occur to the vehicle’s ECM.
D. The Reflash tool should power up and display
three parameters.
1.
Performance Tune
2. Diagnostics
3. Options
E. Select “Performance Tune” and press the
enter button in the middle of the arrow keys.
(See Fig 17-c.)
F. Read the disclaimer entirely, then select
agree and press ENTER.
G. At this point please read the screen displayed
on the reflash tool. If you have any questions,
either refer to the manual that is provided
with the reflash tool or contact our service
department for further assistance.
H. Turn the ignition on (do not start the vehicle).
Set the parking brake and press the ENTER
button to continue.
I. SELECT TUNE will be displayed at the top of
the screen. Use the arrow keys to select the
appropriate tune for your vehicle and press
the ENTER button. You will have a choice of
three to choose from:
1.
SVT STD
2. SVT HO
3. Original Backup
J. Continue to follow the screen and when fin-
ished unplug the reflash tool from the vehi-
cles OBD2 port.
IMPORTANT! To ensure trouble-free programming of your vehicle's computer:
• Make sure the vehicle's battery is sufficiently charged.
• Turn off all accessories and close doors to prevent unnecessary drain on the battery.
• Do not attempt to program your vehicle while a battery charger is connected.
• Improper battery voltage will result in failure of the programming process.
• Do not disconnect the cable or turn off the ignition during programming.
NOTE: Do not disturb the cable, or turn the
ignition off during this time. If the pro-
gramming is disrupted, the computer
will not start or run your vehicle!
Fig. 17-b
Fig. 17-c
ESCAPE
ENTER
OR
SELECT
ARROW
KEYS