Velodyne SC-IWBB - Manual (Page 21)

www.velodyne.com SC-IW Installation Manual - 15
NEW CONSTrUCTION INSTALLATION —
dESIGNEr GrILLE
Note: This installation process assumes that the installer has access to the open framed 2x4 studded wall with
16 inch spacing. (In the event that the stud spacing is larger, an additional 2x4 or other spacer can be used to
fill the space between the SC-IW back box and the neighboring stud.)
Step 1 - Assemble Cabinet and Driver Modules Together
Remove both the back box and driver modules from the packaging and place them on a clean surface. Place
the back box with the two silicon rubber tubes facing upward. Remove the two clamp rings from the packaging
and place them over the tubes.
Figures 13a and 13b: Cabinet and Driver Module Assembly
Note: Leave the paint cover on the driver to prevent damage during the installation, painting and finishing
process.