Velodyne SC-IWBB - Manual (Page 13)

www.velodyne.com SC-IW Installation Manual - 7
Step 5 - Finish Wall
The wall can now be finished in a traditional fashion utilizing the appropriate drywall thickness, standard
texturing and finishing methods. Be sure to advise the “finishing” contractors that they are to drywall up to the
edge of the mudring, as the mudring is the place holder for the installation of the driver module and standard
grille.
Figure 4: Finish Wall
Note: Steps 6 through 14 presume that you have obtained and are ready to install the SC-IwdVR (In-wall driver
Module).
Step 6 - Verify Drywall was Properly Installed
Once the wall is finished, the installer must revisit the installation site and verify that the contractors have
properly used the mudring as their guide leaving an opening that is approximately 16 1/2” x 13 1/4”.