Ubiquiti Networks UniF AP AC Outdoor - Manual (Page 46)

43
Chapter 10: User/Guest Details UniFi ® Controller User Guide
Ubiquiti Networks, Inc.
Chapter 10: User/Guest Details
The User and Guest hyperlinks open the User/Guest Details
window. Unless otherwise needed to specify differences
between the user and guest, this User Guide will refer to
both as user in the rest of this chapter.
The upper part of the window has four clickable tabs:
• Details (see below)
• Statistics (see the next column)
• “History” on page 44
• “Configuration” on page 44
The bottom of the window has two or three buttons:
•
Block Block this user from accessing the network.
• Reconnect Reconnect a user that has been previously
blocked.
• Unauthorize (Available for guests only.) Remove
authorization of wireless guest access and disconnect
the client.
Details
Overview
MAC Address Displays the MAC address of the user.
Hostname Displays the name (if defined).
IP Address Displays the IP address of the Access Point.
Uptime Displays the amount of time the Access Point has
been running without interruption.
Connected AP Displays the name, alias, or MAC address
of the Access Point in use.
If the user is offline, the following information is displayed:
MAC Address Displays the MAC address of the user.
Hostname Displays the name (if defined).
Last Seen Displays the last date and time the user was
connected to the primary or guest network.
Statistics
ESSID Displays the network name or SSID of the wireless
network in use.
Connected AP Displays the name, alias, or MAC address
of the Access Point in use.
Channel Displays the wireless channel in use.
Signal Displays the signal strength.
TX Rate Displays the TX (transmit) rate.
RX Rate Displays the RX (receive) rate.
Activity Displays the level of activity in Bytes per second.
Power Save Displays the status of the power save mode.
Down Pkts / Bytes Displays the amount of data
downloaded by the user in packets and bytes.
Up Pkts / Bytes Displays the amount of data uploaded by
the user in packets and bytes.
Note: The Statistics tab will only appear when the
user is connected.