Spectrum Controls 140 EHC 204 00sc - Manual (Page 5)

Quantum Series 140 EHC 204 00sc 140 EHC 208 00sc
6
Preface
Read this preface to familiarize yourself with the rest of the manual. This preface covers the following topics:
•
What this guide covers
•
Who should use this guide
•
Contents of the guide
•
Related publications
•
Conventions used in this guide
What this Guide Covers
This guide describes the hardware and firmware included in the 4- and 8-channel Quantum™ Counter/Flow
Meter modules for the Schneider Automation Series Quantum PLC. The document contains the information
required to install and wire, configure, use, and troubleshoot the modules.
Who Should Use This Guide
Use this guide if you install, configure, or maintain a control system that uses the module with a PLC. You
should have a basic understanding of Quantum products. Additionally, you should understand electronic
process control and the ladder program instructions required to generate the electronic control signals for the
PLC. If you do not have these prerequisites, contact your local Schneider Alliance representative for the
proper training before using this product.
Manual Contents
The table below lists the contents of this guide.
Table 1 Contents of this Guide
Chapter Description
Chapter 1 An overview of the module
Chapter 2 Installation and wiring guidelines
Chapter 3 Instructions for configuring the module
Chapter 4 Programming instructions
Chapter 5 Information on module diagnostics and troubleshooting
Appendix A Specifications for the module