Spectrum Controls 140 MPM 204 00sc - Manual (Page 57)

Meter Proving Module
59
Corr Corr Corr Corr Corrective ective ective ective ective Action Action Action Action Action
If necessary, install a pull-down resistor between the channel input and channel common or a pull-up resistor
to a positive voltage source.
Module Not Recognized by Rack (ModSoft) Module Not Recognized by Rack (ModSoft) Module Not Recognized by Rack (ModSoft) Module Not Recognized by Rack (ModSoft) Module Not Recognized by Rack (ModSoft)
Possible Causes Possible Causes Possible Causes Possible Causes Possible Causes
•
Module not correctly installed.
•
Module runtime files not correctly installed.
Corr Corr Corr Corr Corrective ective ective ective ective Action Action Action Action Action
1. 1. 1. 1. 1. Reinstall the module in the rack. See chapter 2, “Installation and Wiring.”
2. 2. 2. 2. 2. Check the I/O map screen in ModSoft to see if the problem still exists.
3. 3. 3. 3. 3. If the module name is still marked with an asterisk (indicating a health status problem), select the
module name using the Shift+? key.
4. 4. 4. 4. 4. If the module is not listed at all, reinstall the ModSoft runtime files. See software installation
instructions in chapter 3, “Module Configuration.”