Spectrum Controls 140 MPM 204 00sc - Manual (Page 56)

Quantum Series 140 MPM 204 00sc
58
Active LED Does Not Illuminate Active LED Does Not Illuminate Active LED Does Not Illuminate Active LED Does Not Illuminate Active LED Does Not Illuminate
Possible Causes Possible Causes Possible Causes Possible Causes Possible Causes
The module is not communicating with the PLC rack.
Corr Corr Corr Corr Corrective ective ective ective ective Action Action Action Action Action
1. 1. 1. 1. 1. Deinstall the module. See chapter 2, “Installation and Wiring.”
2. 2. 2. 2. 2. Place the rack in run mode.
3. 3. 3. 3. 3. Reinstall the module in the rack. See chapter 2, “Installation and Wiring.”
Fault LED Does Not Illuminate Fault LED Does Not Illuminate Fault LED Does Not Illuminate Fault LED Does Not Illuminate Fault LED Does Not Illuminate
Possible Causes Possible Causes Possible Causes Possible Causes Possible Causes
•
Module self-test error
•
Fatal hardware error
Corr Corr Corr Corr Corrective ective ective ective ective Action Action Action Action Action
Contact your local distributor.
Fault LED Blinking Red Fault LED Blinking Red Fault LED Blinking Red Fault LED Blinking Red Fault LED Blinking Red
Possible Causes Possible Causes Possible Causes Possible Causes Possible Causes
Type of self-test error. Possible codes are indicated in the Diagnostic LEDs section of chapter 1, “Overview.”
Corr Corr Corr Corr Corrective ective ective ective ective Action Action Action Action Action
Verify module configuration information.
No Signal Indication No Signal Indication No Signal Indication No Signal Indication No Signal Indication
There is no indication of a signal in the input register count rate word. If status bit 3x+1 - 3x+8 (Bit 14)
(counter input state) is high and status bit 4 (rate zero) is high.
Possible Causes Possible Causes Possible Causes Possible Causes Possible Causes
If you have an open collector output or a relay or contact type output, you might require a 1 to10 kohm pull-
up / pull-down resistor.