Spectrum Controls 1769sc-HART Modules - Manual (Page 49)

Chapter 5: Configuring the OF4IH for A MicroLogix 1500 Using RSLogix 500
User’s Manual 0300217-03 Rev. A
5-7
5. Right mouse click and select paste.
Figure 5-9 (Copying Routines)
5.3.2 Copying Ladder from the Sample Project
To copy ladder, follow the procedure below:
1. Open the sample project and your project
2. Open the routine that you wish to copy the ladder from.
3. Select the rungs by clicking the left mouse button. To select more rungs, select
the first rung you wish to copy and while holding the shift key, select the last
rung you wish to copy.
4. Right mouse click and select copy.
5. Open the routine in your project where you wish to place the new rungs.
6. Select the paste point by left mouse clicking.
7. Right mouse click and select paste.
Copy
and
paste
Sample
Project
Your
Project