Spectrum Controls 1769sc-HART Modules - Manual (Page 24)

Compact IO™ Isolated HART Analog Output Module
User’s Manual 0300217-03 Rev. A
3-6
Figure 3-3
3.5.2 Panel Mounting
Mount the module to a panel using two screws per module. Use M4 or #8 panhead
screws. Mounting screws are required on every module.
Panel Mounting Using the Dimensional Template
Figure 3-4
Panel Mounting Procedure Using Modules as a Template
The following procedure allows you to use the assembled modules as a template for
drilling holes in the panel. If you have sophisticated panel mounting equipment, you can
use the dimensional template provided on the previous page. Due to module mounting
hole tolerance, it is important to follow these procedures:
1. On a clean work surface, assemble no more than three modules.