Martin Christ Epsilon 2-4 LSCplus - Manual (Page 35)

Freeze-dryer EPSILON 1-4 LSCplus
Freeze-dryer EPSILON 2-4 LSCplus
5 Set-up and connection
Version 04/2014, Rev. 1.4 of 09/12/2014 • sb
35
Translation of the original operating manual
Pos: 100 /20 0 Ch rist/3 61 G T-BA L abo r-Pilot (PROJEKTE)/Epsilo n 2 -4 LSC plus Sta nda rd/0 50 Auf stellu ng u nd Ansc hluss/ 050 -00 40 Vak uum messs ond e E1- 4_2 -4 @ 25\ mod _14 049 847 357 96_ 68.d ocx @ 186 057 @ 2 @ 1
5.3 Vacuum sensor
NOTE
Please refer to the separate operating manual of the vacuum sensor!
In order to protect the vacuum sensor against transport damage, it comes
supplied in its original packaging. Prior to commissioning the freeze-dryer,
the sensor must be installed.
1
Vacuum sensor
2 Electrical connection
of the vacuum sensor
Fig. 15: Position of the vacuum sensor and electrical connection
• Switch the unit off by actuating the mains power switch.
• Take the vacuum sensor out of its original packaging and fasten it to the
connector with a clamping ring (DIN16KF) and a centring ring (both
included in the scope of supply).
• Plug the connector (installed on the unit) onto the vacuum sensor and
hand-tighten the screw on the connector.
NOTE
It is absolutely essential to comply with the manufacturer’s instructions in
the separate operating manual of the vacuum sensor!