Lumagen VisionPro - Manual (Page 9)

Vision Pro
™ User Manual and Installer Guide
© 2003 Lumagen, Inc. 6 Rev 1.13
Installer Guide
Installation
Unpack the shipping container. Save the container and packing materials incase they are
needed later. Place the
VisionPro Video Processor on a component shelf and connect as
described in the Rear Panel section. The cooling vents must be clear of obstructions to
provide for convection cooling.
Install the two AAA batteries in the remote control.
The following items should be included:
VisionPro Video Processor
Infrared remote control with 4 AAA batteries
Three RCA-female to BNC-male adaptors
Two S-Video to BNC-male adaptor cables
Two sets of three RCA-male to BNC-male adaptor cables for component inputs
External power supply with power cord
Two 19” rack mount adaptors
User manual
License agreement
Warranty card
Front Panel
The front panel has an LCD status display with backlight, along with power, input select
and aspect ratio select switches, plus an infrared sensor for remote control commands.
The LCD display is illuminated for a short time after infrared commands are received. It
is then darkened to prevent it from being an unwanted light-source. This behavior can be
changed so that the LCD light stays on as a “power-on” indicator by pressing MENU, 0,
9, 2, 5 on the remote and then saving the change, as described in the Installation
Commands section, to make it permanent to make it permanent.
The front panel is shown below.
POWER INPUT ASPECT
VisionPro
Video Processor
LCD display with backlight
Power
IR sensor
Aspect Ratio
Input select