Lumagen VisionPro - Manual (Page 18)

Vision Pro
™ User Manual and Installer Guide
© 2003 Lumagen, Inc. 15 Rev 1.13
Installation Commands
See the Command Format section for a description of the installation command interface.
Display Setup
The factory-default video output is set to RGBHV with negative sync, 480p, 60-Hertz
vertical-refresh-rate, and a 1.78 (16:9) screen aspect-ratio.
The factory-default mode is for all configuration memories to use a single output setup.
Alternately, independent output settings can be selected (see Multiple Output Settings).
Display Type
Select the video output color-space and synchronization type. The selection takes effect
immediately. The arrow keys are then active and have immediate effect. Press the
OK
key when done to prevent the arrow keys from continuing to change the sync type.
RGBHV: MENU , 1 , 2 , [ , ] , [ , ], OK
sets both H and V sync as negative (default)
sets both H and V sync as positive.
sets negative H sync. If needed, select after the or key.
sets positive H sync. If needed, select after the or key.
RGBS: MENU , 1 , 3 , [ , ], OK
sets negative composite sync (default)
sets positive composite sync
RGsB:
MENU
,
1
,
4
, [
,
],
OK
sets embedded bilevel sync
sets embedded trilevel sync (default)
YP
R
P
B
: MENU , 1 , 1 , [ , ], OK
sets embedded bilevel sync
sets embedded trilevel sync (default)
Default: The respective default is selected if no arrow key is pressed.
Vertical Resolution - Presets
Set the output active vertical resolution to one of eight preset values. See the Selecting the
Output Resolution section for more information. This command maintains the current
display type, aspect ratio, and vertical refresh rate. The only interlaced format supported
is 1080i at 60, or 50, Hertz. The command format for each resolution is:
480p: MENU , 2 , 1 , OK 540p: MENU , 2 , 2 , OK 600p:
MENU
,
2
,
3
,
OK
720p:
MENU
,
2
,
4
,
OK
768p:
MENU
,
2
,
5
,
OK
840p:
MENU , 2 , 6 , OK
1080p: MENU , 2 , 7 , OK 1080i: MENU , 2 , 8 , OK