Lumagen VisionPro - Manual (Page 24)

Vision Pro
™ User Manual and Installer Guide
© 2003 Lumagen, Inc. 21 Rev 1.13
Lock the Configuration
The configuration can be locked to prevent unintended changes. When locked, the input
selection keys function normally, but setup parameters are fixed. The command format is:
MENU → MISC → LOCK →
( UNLOCKED , LOCKED) , OK
The following command can unlock the configuration memories without being able to
see the screen.
MENU 0 9 1 5
Same as
MENU →
MISC
→
LOCK
→
UNLOCKED,
OK
Initial Power State
When power is first connected to the unit, it can be set to turn on ( ON) , or it can start in
standby mode ( STBY) . Note, ON and STBY commands are not affected. The command
format is:
MENU → MISC → POWR → AUTO →
( ON , STBY) , OK
Power-On Message
A user generated text message can be displayed when power is applied, or the
ON
key is
pressed. The and arrows select which character to change. The and arrows change
the selected character. The command format is:
MENU → MISC → POWR → MSG →
[ , , , ], OK
Test Patterns
Warning:
Test patterns can cause screen burn-in. Do not leave
test patterns displayed for more than a few seconds.
There are several test patterns available. The and arrows select the test pattern. The
intensity can be adjusted from 10 to 100 IRE, in 10 IRE steps, using the and arrows.
The command format is:
MENU → MISC → TPAT → OK , [ , , , ]
Genlock
Genlock puts the input and output frames in “lock-step.” When enabled, genlock makes
sure all input frames arrive at the output a fixed time later. In other words, no frames are
dropped and none are repeated. Very few people can notice any difference whether
Genlock is enabled or disabled (default). Note: Not all displays are capable of
synchronizing to the slightly different timing Genlock produces. If the image is not
stable, or not visible, disable Genlock. To enable Genlock:
MENU 0 9 8 1
Toggle genlock. Default = off. (can be saved)
To check the status of Genlock:
MENU 0 9 8 2
Genlock status (off, locked, unlocked)