Lumagen VisionPro - Manual (Page 23)

Vision Pro
™ User Manual and Installer Guide
© 2003 Lumagen, Inc. 20 Rev 1.13
Input Black Pedestal
Note:
For best video quality, the Input Black Pedestal must be set correctly. For Composite and
SVideo sources, 7.5 IRE is generally correct. Many component sources use 0 IRE. Check
the manual of the source device to be sure which setting is correct. If unsure, use 0 IRE.
This command specifies if there is an input black pedestal. The command format is:
MENU → IN → ADJ → PDSTL →
( 7.5 IRE, 0 IRE ), OK
Input Black Enhance
This command expands the lowest 2% of the input range (0 to 2 IRE) slightly. This can
help to make black backgrounds appear darker verses the 4 IRE level used in some
PLUGE patterns. The command format is:
MENU → IN → ADJ → ENHNCE →
( BLACK, OFF ), OK
Pass-through Sync Processing
Select the pass-through sync processing mode. If processing is enabled, pass-through
sync signal polarity is processed to match internally generated sync levels. In this case,
the pass-through sync type must match the internally generated sync type. If pass-through
sync buffering is selected, the sync signals are simply buffered.
MENU → IN → ADJ → SYNC →
( PROCESS, BUFFER ), OK
Input Name
Each input configuration memory can be named. Follow the on-screen directions. The
and arrows select which input to change and then which character to change. The
and arrows change the selected character. The command format is:
MENU → IN → NAME
Copy Input Settings
Copy the input setup (contrast, etc.) from the active memory, to the selected memory, or
memories. Since the parameters for the first input calibrated will likely be closer to
optimal than the factory defaults, this command can speed up the calibration process.
The command format is:
MENU → IN → COPY →
( ALL, ALLMEMA, ALLMEMB, 1A – 8A , 1B – 8B ), OK
Miscellaneous Commands
On-Screen-Display Enable
Enable or disable On-Screen-Display (OSD) activation after user commands. If enabled,
the OSD shows the selected input, input aspect ratio, and zoom.
MENU → MISC → OSD →
( OFF , ON) , OK