Lumagen VisionPro - Manual (Page 17)

Vision Pro
™ User Manual and Installer Guide
© 2003 Lumagen, Inc. 14 Rev 1.13
Command Format
VisionPro commands are selected with the supplied infrared remote, or the RS232 serial
port. To prevent possible command conflict, only one of these inputs should be used at a
time.
The infrared remote control command notation is described below:
•
Remote buttons are named as shown on the remote in a bold font.
Example: MENU .
•
For comma separated lists, press the buttons in the sequence shown.
Example: For the list
RGBHV
,
OK
, press
RGBHV
then
OK
.
•
For parenthesized lists, select one button from the list.
•
For square-bracketed lists, press as needed.
Example: For the list [ , , , ], press the arrow keys as needed.
•
For menu commands press the
MENU
button. The , and arrow keys are used to
select the function. The arrow key is used to enter sub-menus. This is shown as:
MENU → MenuItem → MenuItem.
•
Numerical entries are listed as
value
. While entering the value, the arrow key acts as
a backspace key.
•
Some commands are activated immediately. Other commands must be explicitly
accepted by pressing OK . If needed, OK is listed as part of the command.
•
Pressing EXIT cancels a partially completed command. If the menu system is active,
EXIT returns to one level higher in the menu system.
•
There are two independent configuration memory types for each input (
MEMA
, and
MEMB
). The input setup and output resolution/timing can be set independently for
each memory. Note that, initially, there is a single output mode for all configuration
memories. To program an input memory, first select the input, then press the
appropriate configuration memory button, and use the menu system to configure.
•
Some menu commands are only available when their respective input is selected.
Example: Calibration commands, such as contrast, are not available when the pass-
through input is selected.
•
Before changes are saved, they can be discarded by entering standby mode.
•
Save the configuration after making changes, or they will be lost when entering
STBY
mode.
•
To prevent unintended configuration modifications, after saving, use the lock
command.
If the serial port is used, the ASCII character associated with the respective remote
control button must be sent. See the Serial Interface section for information on serial
commands.